How to Split an Over The Air Antenna Signal to Multiple TV’s

Originally Posted by Sam Spastic The cable chaser is overkill. Just try the other cables one at a time and see if one works. The cable in the main viewing room is probably hooked up to the splitter, as the previous resident was using Fios? I’ll let others comment on the antenna choice. You have tried at least one of these cables and found it unsuitable for OTA reception. You can try all other pre drilled alternates to see if they are equally bad, or alternately you may find at least one that marginally works. But how can you find out if any of your pre drilled cable alternates preform as well as RG-6 coax, basically the coax of choice for OTA television reception?

How to Connect Multiple TVs to your OTA Antenna

Ask Question Step 3: Antenna Installation If you chose to install your antenna using the wall mount, you need to drill pilot holes for the bolts that will anchor the braces to the wall. Do not drill on the brick but instead drill on the mortar which is softer than the brick. Make sure that you leave a space of approximately 12 to 14 inches between the brace on top and the one below.

This will make sure that the mast will not sway with the wind. If one or two holes are too big for the bolt, which sometimes happens, simply use plastic expansions inside the pilot holes and screw the bolt again.

Winegard Company is the leading manufacturer of HDTV over-the-air antennas. Building on 50 plus years of antenna design and manufacturing heritage, having developed the highest quality, cutting-edge technology antennas for free uncompressed HDTV and digital reception.

Looking for more information or troubleshooting your antenna? If you still don’t find what you are looking for please check out our Digital Reception Tips page or feel free to use our Ask the Engineer section to have one of our highly trained TERK Antenna Technicians help you with resolving meeting your need. What type of antenna do I need? It depends on your situation; factors determining what type of antenna depend on the distance and direction from the TV station transmitters to your home.

Other factors include the transmitter’s power and tower height and any obstacles hills, buildings, etc.. To help you figure what best fits your need use our Antenna Finder in the top left corner of this page. Do I need an indoor or outdoor antenna? Good question, answer depends on your situation. The main factors determining reception are the distance and direction from the TV station transmitters to your home. If you live within a few miles of the transmitter, and the signal path is relatively unobstructed, you may be able to get adequate reception using an indoor antenna.

But as you move farther away, getting usable signal strength becomes trickier. This is where careful antenna selection and installation become essential.

Outdoor TV Antennas

The answer is simple. Purchase a specialized antenna designed to pick up over the air broadcasting from the local HDTV stations in your area. It will vary widely based on your location. In some cases if you are in remote locations you may not get even one station.

The power output of most routers cannot be altered, so even though a lengthier external antenna may work around objects better, it won’t magnify the power output.

This is an inexpensive device that will split your OTA signal into multiple sub-signals, allowing you to push free TV broadcasting to multiple TVs. So if you have a weak or marginal signal coming from your antenna, splitting it will have a negative effect. Finally the more distance the signal has to travel, the weaker the signal becomes. So less feet in coaxial cable, means stronger signal, equating to better picture quality.

Be careful with 3 way splitters. Signal loss can vary substantially across the three outputs. Meaning if used, two TVs could work fine, while the third would suffer from a weaker signal. I did some research and found an example of a Splitter that addresses this issue: Click here to read the reviews: Connect Your Main TV I dont suggest connecting more than one TV at a time because if something goes wrong you wont know where the issue is.

How to Connect an Antenna or Cable to Your HDTV

You are transforming the 4-conductor telephone cable into a loop with 4 turns of wire. My home-made circuit continuity tester has both a beeper and a light that come on when the circuit is closed. Twist the two long wires together so that they have approximately 2 turns per inch.

Home Kit For Sirius Radios. User Guide. 3. Table of Contents. Connect the Indoor/Outdoor Antenna Once you have selected a location, connect the antenna to the ANT connector at the rear of the Home Dock. (After completing a few additional steps, we will work where to place your Home Antenna? Look up your location on an online.

For a professional installation from our partner InstallerNet, click here Please note the following important factors in determining zBoost performance: At least 15 vertical feet is needed between the External Antenna receives the outside signal and the Indoor Antenna rebroadcasts the signal indoors. Separation less than 15 vertical feet will result in decreased performance. Generally, increasing this distance up to 40 feet will increase the performance and decreasing the distance will limit zBoost performance.

Proximity of metal or wireless access points: The Base Unit must remain at least 3 feet away from metal objects and other electronic devices. If there is no signal, the zBoost will not work for you. Using your cell phone, place a call from an outdoor location to confirm that enough signal is present to complete the call. If a weak signal is available at ground level, check the signal strength in your attic or at roof level location where the signal will likely be stronger and where the External Antenna can be placed for best performance.

If you can reliably make and receive calls outside your home, then zBoost can bring the signal into your home. If only one signal bar is displayed on your cell phone outside, indoor coverage will be limited to one small room. Antenna Separation At least 15 vertical feet is needed between the External Antenna receives the outside signal and the Indoor Antenna rebroadcasts the signal indoors. Choose a location using your cell phone to determine the area of strongest signal – typically found outside, above the roofline or in an attic.

Is Free HDTV Right For You?

A lot of great content is accessible via the Internet, from sources like YouTube, Netflix, iTunes, and others. But will your old antenna work with modern, digital TV? In our case, the antenna was a large, s multi-directional behemoth that was hanging in our attic, unused for decades. However, my dad remembered it working quite well for analog TV, before cable was available in our area, so we decided it was worth the risk to try wiring it back up. For TV wiring, it converts old ohm twin-lead wire to new ohm coaxial wire.

“how many tvs can i hook up to this antena and what items would be needed to run 4 tvs off this 1 antena” ClearStream 4MAX Indoor/Outdoor HDTV Antenna – Black. () of 5 Answers. We’re running 6 TVs off of this using a HDHomeRun Quatro to wirelessly transmit the signal from the antenna to the TVs. The Quatro has 4 tuners so as.

This wikiHow teaches you how to select and set up an antenna for your TV. Steps Preparing to Connect 1 Determine your television’s antenna connector type. Virtually every TV has an antenna input on the back or side; this is where you’ll plug in the antenna. There are two main versions of this input: Coaxial RF – Resembles a threaded cylinder with a hole in the middle. This type of connector is the standard for most modern TVs. IEC – Resembles a smooth cylinder with a smaller cylinder inside of it.

Check your TV’s manual or look up its model number online to double-check the antenna type. You can typically do this by typing in your location and “tv broadcast station” into Google. This will give you an idea of the type of antenna that you’ll need; for example, if the closest station is relatively far away, a standard set of “rabbit ears” won’t be ideal.

Sky® 60 Attic / Outdoor HDTV Antenna

Indoor antennas work well in areas where the television signal is strong, but reception deteriorates if tall buildings block the signal or if your home is in a valley. With a head for heights you can install and hook up your TV to an outside antenna without the cost of hiring a contractor. Attach the antenna to the antenna pole following the instructions provided.

Twist the coax around the antenna pole with one complete turn per foot and secure with electrical tape.

If your unit didn’t come with directions, I would look up the manual for it on the manufacturer’s website, or call their technical assistance hotline. Both should be listed on the antenna’s packaging.

The most common way is via an antenna or cable box. Since most over the air television stations broadcast in HD signal, you can get high definition versions of most network shows using a good old fashion, rabbit ear antenna — if you live in a city or metropolitan area. The first step to connect an antenna, is to find the input port on your HDTV. Your antenna attaches with a cable — it has an F connector.

The screw on connector may be a little challenging for the first couple of turns. Once you get it started, it screws on easily. If you subscribe to a cable or satellite television service, your HD and non-HD channels probably come in from a receiver that you connect to your HDTV. You have a few options for how to connect this receiver. The first step is to connect the box to the cable; it brings the television signal into your house. You should have a cable with an RF connector on the end that looks similar to the cable you used with the antenna.

Attach that to the box at the jack labeled input.

Get FREE TV – Replace DirecTV with an Off-the-Air Antenna